Dialogic PCI Linecard Installation and Replacement
R3B
ã
Aug 2001 Ericsson Enterprise AB
46
The Remote Loopback Switch (SW500)
The Remote Loopback Switch is factory configured to the left (Off) position for normal
mode (default), as shown in Figures 15. Once the firmware is downloaded, you can set
the Remote Loopback Switch to the right (On) position for loopback mode, as shown in
Figure 16. Loopback mode enables you to verify the T-1 connection. The switch
overrides any board modes set by the Dialogic System Software. The Remote Loopback
Test Indicator above the Remote Loopback Switch will light when the linecard is set to
loopback mode.
Figure 15. Rear bracket of the
D/240PCI-T1
Figure 16. SW500 remote
loopback switch set to the
On position
RJ-48C
Remote Loopback
Switch (SW500) is
in the off position.
Power LED
Yellow LED
Green LED
Red LED
Loopback LED
White box
represents the
switch in the on
position.
