9100-127-2989-99 REV B
1501 Route 34 South, Farmingdale, NJ 07727
Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com
10
Commissioning
NOTE:
In order to confirm proper location it is advised to mount the sensor before discovering
it.
Adding Sensor to Gateway
1.
When the green LED blinks twice a second on the sensor, the sensor is ready to be
discovered/commissioned.
2.
Use a Dialight gateway to discover the sensor. (Please refer to the gateway owner’s
manual for further instructions under the devices page.)
3.
Once the sensor has been added to the gateway, the green LED will stop blinking at
the rate of twice a second. You have now connected the sensor to the gateway.
4.
The green LED will then blink when motion is detected.
NOTE:
There is a 90 second ideal mode after a trigger detection. Thus quick repeating
will not trigger additional events.
See the Gateway manual for setting up the sensor
Removing the Sensor from a Gateway
Due to failure or relocation
1.
Go to the sensor and open it and hold the SW3 Leave button for 5 seconds
2.
Sensor LED’s should now be double blinking
3.
Check the gateway’s GUI to verify sensor was removed from device list. (Please refer to
your gateway owner’s manual for further instructions.)
4.
Your sensor is now ready to be added to another gateway.
SW3 LEAVE
SW1 RESET
SW2 JOIN
