RK10
RK10
RK10
RK10S
S
S
S
Roofing saw
Page 8 of 8
4.3.
Termination of work
1. Stop the engine and shut off the fuel, implement all steps described in the engine
manual.
2. Clean the machine including the inside of the tool cover and check the wear of the tool.
3. Store the chaser in safe and dry place.
5.
MAINTENANCE
The basic steps of preventive maintenance described in this manual can be carried out by
the operator appointed by the entrepreneur. We recommend that all repairs and
adjustments beyond the scope of this manual are carried out by authorised service centre.
!ATTENTION! In the guarantee period it is prohibited to interfere with the engine and
power transmitting components in any manner whatsoever!
!ATTENTION ! It is prohibited to change the rev setting in any way!
5.1.
Cleaning of the machine
Regular cleaning prolong the life of the machine its components and tools. After finishing
work clean the machine from dust and dirt by wet cloth or air before storing. Never use
pressurised water for cleaning.
5.2.
Checking screw joints
Check the tightness of screw joints before every start of the machine. Regularly check the
tightness of tool fastening nut.
5.3.
Engine maintenance
See engine manual.
Take extra care about cleanness of the engine and its cooling fins. Dirty engine=short life.
Clean the air filter regularly even during single shift if necessary. If the chaser is not used
in two month, change the oil.
5.4.
Tool maintenance
Regularly check the wear and soiling of tools. If the TC tips are almost worn off, change
the tool.
5.5.
Inspection of tautness of V belts
Regularly check the tautness of the V belts. The deflection of the V belt under the
pressure of an index finger should be approximately 20 mm.
If the v belts needed to be drawn tauter proceed as follows:
Always carry this operation with cold, switched off engine.
1. Loosen the four bolts by which the engine is mounted on the undercarriage.
2. Push the engine backwards.
(You can check the tautness of the belts trough the hole in the V belt cover.), Retighten
the bolts
