Diagraph PA/4000, Service Manual, Page: 46 / 213

PA/4000 User’s Manual
Section 5, Configuration
Page 7
Auto-Retract - Enables or Disables the Auto-Retract feature of the
PA/4000. The Auto-Retract sensor is located on the tamp pad. It senses
the product when the tamp pad extends to apply a label, then commands
the tamp pad to retract to the home position. If the sensor does not detect
a product, or if the sensor is turned OFF from the Hand-Held Terminal,
the cylinder will remain in the extended position until the TAMP DWELL
time has expired.
Darkness – Adjusts the level of darkness (printhead temperature) in a
printhead. It is used to balance a new printhead so that it prints at the
same level of darkness as the previous head. Darkness values are from 1
to 99. Start with a midrange number and work from there.
Feed (Apply Label) [E]
Provided there is not a label present on the tamp pad already,
the FEED key will advance the paper automatically to the
first print position of the next label. On a new size label, two labels are
usually fed before registration occurs. Pressing the FEED key in conjunction
with the 2nd key will cause the system to apply a label.
NOTE: The tamp assembly will not cycle unless a label is present on
the tamp pad.
Pause/Resume [F]
The PAUSE/RESUME key allows you to pause the
printing of a run of labels. A second depression of the key
will resume the job. Activation of this key will do the following:
•
Stop the print mechanism when the label being printed is completed
•
Stop the label counter, but maintain the count balance
•
Hold all data in memory
•
Disable tamp applicators and disable photosensor out signal
NOTE: On the PA/4020 model, the disabling of the photosensor out
signal will in turn prevent the secondary wipe-down from being
activated by photosensor 1 or 2.
APPLY
LABEL
NU/
ECT
FEED
[E]
PAUSE/
RESUME
STO
CLE
[F]