36
DHOLLANDIA
14.3
ROUTING OF THE WIRE LOOM
•
The wire loom of the slider liftgate is housed in a protective conduit [4] that runs from the side of the pump unit to the external control
box.
•
The kit bag contains minimum one, sometimes more mounting bracket(s) [1-2] to attach the conduit [4] to the slide tube [3].
•
If only 1 bracket [1] is supplied, it must be mounted as far as possible towards the front of the slide tube, without being pulled back
when the lift frame stands in its work position.
•
If 2 brackets [1-2] are supplied, [1] must be mounted as above, the 2nd [2] in an intermediate position between the 1st [1] and the
control box.
•
Verify the routing of the conduit [4] and wire loom both at travel position and work position of the liftgate. Make sure the conduit [4]
cannot be stretched, squeezed, caught or damaged otherwise while sliding the lift frame and pump unit in / out.
•
Readjust and fine-tune the position of the mounting bracket(s) [1-2] if required.
Summary of Contents for DH-SM
