Dhollandia DH-S Series, Installation Manual

Page: 30 / 82

29
DHOLLANDIA
9.4 STEEL SLIDING TUBES
•
The steel sliding tubes for trailer / semi-trailer chassis have predetermined mounting positions [see Figure 9.17]. Their position on
the vehicle chassis is fixed.
9.5 MOUNTING THE SLIDING TUBES TO THE VEHICLE CHASSIS
•
Validate the mounting position of the liftgate and its sliding tubes
before fastening the mounting brackets. If the sliding tubes would not
fit in the initial setup of the end stops, these can be moved and
adjusted accordingly. The tubes can also be shortened in order to
allow them to fit [see Figure 9.18].
•
When fastening the mounting brackets and the sliding tubes, make
sure the alignment in all directions is correct.
1. The alignment of the mounting brackets in comparison to the
chassis [see 1 in Figure 9.19].
2. Except for chamfered chassis, the parallelism of the sliding
tubes to the chassis. [2 in Figure 9.19]
3. The parallelism between the 2 sliding tubes, one in comparison
to the other. [3 in Figure 9.19]
EX.
EX.
Figure 9.17
Figure 9.18
Figure 9.19
❷
❶
❸