
2 - 18
Chapter 2: RM3200D System Design
2.3 Hardware Modules
2.3.2.12 Multichannel Module (MADI) RM330-421
2.3.3 Control Desk
The control desk uses exclusively sturdy and longlife Lumitas keys. These can be equipped
with either bulbs (factory default) or Multichip-LEDs (option). Please note that the bulbs are
much brighter then the Multichip-LEDs.
For displays, green LED-ASCII-displays are used. Thus, an excellent visibility is provided
also in bad lighting conditions.
The control surface can entirely be configured by the user with several sets of predefined
software functions. You will find a detailed description of the available functions in the
chapter
“Configuration” on page 80
.
On the control desk, there is no special master module, all control desk modules are
working completely independent from each other on the CAN Bus, and all modules are hot
plugable.
•
56 Channels Input /Output, AES10-MADI
•
Fiber Optic Connector for 1300nm-
Multimode Fiber, SC-Connector
•
MADI signal usable as synchronisation
source for the system (only on slot 1)
•
BNC input for TTL-wordclock as
synchronization source for the system (only
on slot 1) or BNC output for TTL-wordclock
(operates with the current system sampling
frequency)
•
per jumper switchable phase inversion for
the in- and outputs of the TTL- wordclock
(refer to section
Jumper Settings on
page 171
)
•
high accuracy PLL circuits for the 44.1kHz
and 48kHz with ±75ppm locking range and
low accuracy PLL circuit with 30...48.5kHz
locking range
•
internal quartzes 44.1kHz and 48kHz,
accuracy ±10ppm for 44.1kHz and 48kHz
Figure 16: Multichannel Module RM330-421