DH Instruments E-DWT-H, Operation And Maintenance Manual

Page: 50 / 126

E-DWT-H OPERATION AND MAINTENANCE MANUAL
© 2009 DH Instruments, a Fluke Company Page 40
Note
•
Pressing [ENT] from the main run screen when the
Deviation DISPLAY is active goes directly to the Target
editing screen. This allows the target value to be
changed and without going through the DISPLAY menu.
•
If the pressure measurement unit or mode is changed
while the Deviation DISPLAY is active the target value
remains at the same numerical value. It is NOT
converted.
•
To go to a DISPLAY other than Deviation, press
[DISPLAY] and make a new DISPLAY choice (see
Section 3.7.7).
3.7.7.4 RPT
 PURPOSE
To activate the Q-RPT DISPLAY (dual Q-RPT RPM4-E-DWT models only).
Note
See Section 3.7.7,  Principle.
 OPERATION
Note
For the sake of clarity, when describing the Q-RPT DISPLAY,
the Q-RPT displayed on the top line of the display when the
Q-RPT function is selected is referred to as the “active” Q-RPT.
The other Q-RPT to be displayed on the second (bottom) line of
the RPM4-E-DWT display is referred to as the “inactive” Q-RPT.
It is “inactive” in the sense that all Q-RPT specific functions and
settings such as UNIT still apply to the “active” Q-RPT. To
make changes to the “inactive” Q-RPT, for example to change
its pressure measurement unit, it must be made the active
Q-RPT by a range change (see Section 3.7.2).
To activate the Q-RPT DISPLAY, press [DISPLAY] , <4RPT> . Operation returns
to the MAIN RUN screen with the inactive Q-RPT displayed on the display’s
bottom line. The range of the inactive Q-RPT is always the default range, not an
AutoRanged range (see Section 3.1.1).
With the Q-RPT DISPLAY active the main run screen is:
1. Active RPT display.
2. Inactive RPT display with Ready/Not Ready
indicator on far left.
9911 psi g zHi
*0.0 psi g zLo