DG Flugzeugbau DG-800A, Maintenance Manual

Page: 71 / 163

Maintenance Manual DG-808C
Issued: May 2012 TN 800/41 4.10
Version with combi tape: Glue the Teflon glass fabric tape to the wing
with 5mm overlap..
Version with dimple tape: Glue the Teflon glass fabric tape to the wing
with 10mm overlap.
Press the Teflon-glass fabric tape with a wooden stick into the gap between
aileron and wing and glue the Teflon-glass fabric tape to the aileron surface.
We recommend to remove only approx. 1m (3 feet) of the cover tape from
the Teflon-glass fabric tape and to glue this section. Continue accordingly
with the next sections.
Then deflect the aileron several times in both directions.
If there is still a noise which sounds like the fabric sticking to the aileron and
getting loose again, you should blow compressed air into the fairings of the
control linkage pushrod to distribute the talcum powder.
Glue a PVC tape (19mm wide) over the leading edge of the sealing.
Execute the work described in section 4.6.2.
Reinstall the combi tape according to section 4.7.2 a).
Sealings shown for version with dimple tape
4.7.4 Winglets 18 m
Zig-zag turbulator (60°, 0,4mm thick) on winglet upper (inner) surface
x
x1 40 mm tip x= 100 mm
x1= 40 mm
x1= rear end of turbulator up to
winglet trailing edge
450 mm
base x= 180 mm
x1= 90 mm