44
3
Award BIOS Setup Utility
Instant-Off
Pressing and then releasing the power button at
once will immediately power off your system.
PWR Lost Resume State
Keep Off
When power returns after an AC power failure, you
must press the Power button to power-on the system.
Turn On
When power returns after an AC power failure, the
system will automatically power-on.
Last State
When power returns after an AC power failure, the
operating session where you left off before power
failure occurs will resume.
Resume On Ring
With an external modem installed, the Modem Ring-on function will
allow your system to power-on to respond to incoming calls. By
default, the Resume on Ring field is Disabled. To use this function,
please follow the steps below.
1. Make sure the computer system is powered off.
2. Connect the external modem to the COM 1 or COM 2 serial
port.
3. Switch on the power of the external modem.
4. Power-on the computer system. After the memory test, press
<Del> to enter the Award BIOS setup utility.
5. Select Power Management Setup and press <Enter>.
6. Enable the Resume on Ring field.
7. Press <Esc> to return to the main menu of the Award BIOS
setup utility. Select Save & Exit Setup and press <Enter>.
8. Type <Y> and press <Enter>.
Resume On LAN
With a LAN card installed, the Wake-On-LAN function allows the
network to remotely wake up a Soft Power Down (Soft-Off) PC.
However, if your system is in the Suspend mode, you can wake-
up the system only through an IRQ or DMA interrupt. Make sure
your LAN card supports the remote wakeup function. To use this
function, set this field to Enabled. Refer to the Wake-On-LAN
Connector section in Chapter 2 of this manual for more
information.
