38
2
Hardware Installation
Front Audio
The front audio connector (J19) allows you to connect to the line-
out and mic-in jacks that are at the front panel of your system.
Using the line-out and mic-in jacks will disable the rear audio’s line-
out and mic-in functions.
Remove the jumper caps from pins 5-6 and pins 9-10 of J19 prior
to connecting the front audio cable connector. Make sure pin 1 of
the cable connector is aligned with pin 1 of J19. If you are not using
this connector, make sure to replace the jumper caps back to their
original pin locations.
BIOS Setting
Configure the onboard audio in the Integrated Peripherals submenu
(“Onboard Device” section) of the BIOS. Refer to chapter 3 for
more information.
Driver Installation
Install the audio driver. Refer to chapter 4 for more information.
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.
Pins 5-6 and 9-10 short
(default)
Pins 5-6 and 9-10 open
2-channel
Line-in
Line-out
Mic-in
4-channel
Rear R/L
Front R/L
Mic-in
6-channel
Rear R/L
Front R/L
Center/Subwoofer
Light Blue
Lime
Pink
