42
2
Hardware Installation
Front Audio
The front audio connector (J2) allows you to connect to the line-out
and mic-in jacks that are at the front panel of your system. Using the
line-out and mic-in jacks will disable the rear audio’s line-out and mic-
in functions.
Remove the jumper caps from pins 5-6 and pins 9-10 prior to
connecting the front audio cable connector. Make sure pin 1 of the
cable connector is aligned with pin 1 of the front audio connector. If
you are not using this connector, make sure to replace the jumper
caps back to their original pin locations.
BIOS Setting
Configure the onboard audio in the Integrated Peripherals submenu
(“Onboard Device” section) of the BIOS. Refer to chapter 3 for
more information.
Driver Installation
Install the audio driver. Refer to chapter 4 for more information.
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.
Pins 5-6 and 9-10 short
(default)
Pins 5-6 and 9-10 open
