43
DISPLAY SWITCH IS SET INCORRECTLY
Display switch on the motherboard can be set to either monochrome
or color. This indicates the switch is set to a different setting than indi-
cated in Setup. Determine which setting is correct, and then either turn
off the system and change the jumper, or enter Setup and change the
VIDEO selection.
ERROR ENCOUNTERED INITIALIZING HARD DRIVE
Hard drive cannot be initialize. Be sure the adapter is installed correctly
and all cables are correctly and firmly attached. Also, be sure the cor-
rect hard drive type is selected in Setup (refer to Appendix G).
ERROR INITIALIZING HARD DISK CONTROLLER
Cannot initialize controller. Make sure the card is correctly and firmly
installed in the bus. Be sure the correct hard drive type is selected in
Setup. Also, check to see if any jumper needs to be set correctly on the
hard drive.
FLOPPY DISK CNTRLR ERROR OR NO CNTRLR PRESENT
Cannot find or initialize the floppy drive controller. Make sure the con-
troller is installed correctly and firmly. If there are no floppy drives in-
stalled, be sure the Diskette Drive selection in Setup is set to NONE.
KEYBOARD ERROR OR NO KEYBOARD PRESENT
Cannot initialize the keyboard. Make sure the keyboard is attached cor-
rectly and no keys are being pressed during the boot.
If you are purposely configuring the system without a keyboard, set the
error halt condition in Setup to HALT ON ALL, BUT KEYBOARD. This
will cause the BIOS to ignore the missing keyboard and continue the
boot.
MEMORY ADDRESS ERROR AT...
Indicates a memory address error at a specific location. You can use
this location along with the memory map for your system to find and
replace the bad memory chips.
