2
Hardware Installation
35
The system board supports Enhanced IDE or ATA-2, ATA/33 or
ATA/66 hard drives. We recommend that you use hard drives from
the same manufacturer. In a few cases, drives from two different
manufacturers will not function properly when used together. The
problem lies in the hard drives, not the system board.
Important:
If you encountered problems while using an ATAPI CD-ROM
drive that is set in Master mode, please set the CD-ROM drive
to Slave mode. Some ATAPI CD-ROMs may not be recognized
and cannot be used if incorrectly set in Master mode.
2.10.6 Universal Serial Bus Ports
The system board is equipped with two
USB ports (CN11 - Black) located at
the ATX double deck por ts of the
board. USB allows data exchange
between your computer and a wide
range of simultaneously accessible
external Plug and Play peripherals. You
must have the proper drivers installed in
your operating system to use the USB
ports. Refer to your operating systems
manual or documentation.
The system board supports the Wake-
On-USB Keyboard function. This function
allows you to use a USB keyboard to
wake up a system that is in the S3 (STR - Suspend To RAM) state.
If you want to use this function, you must set jumper JP12 pins 2
and 3 to On and set USB KB Wake Up From S3 in the Power
Management Setup submenu of the BIOS to Enabled. Refer to
Jumper Settings for Wake-On-USB Keyboard in chapter 2 and
USB KB Wake-Up From S3 in the Power Management Setup
section in chapter 3 for more information.
