43
Chapter 3
BIOS SETTINGS
User's Manual |
CMS631
InsydeH2O Setup Utility
Rev. 5.0
F1
Help
Esc
Exit
↑/↓
Select Item
←/→
Select Item
F5/F6
Change Values
Enter
Select
X
SubMenu
F9
Setup Defaults
F10
Save and Exit
TPM Availability
Show or hide the TPM availability and its configurations.
TPM Operation
Select one of the supported operation to change TPM2 state — No Operation, Enable, or Dis-
able.
Clear TPM
Remove all TPM context associated with a specific Owner.
Set Supervisor Password
Set the supervisor’s password. The length of the password must be greater than one character.
When Hidden, don’t ex-
poses TPM to 0
Current TPM Device
TPM State
TPM Availability
TPM Operation
Clear TPM
Supervisor Password
Set Supervisor Password
Boot
Exit
X
Security
<TPM 2.0 (DTPM)>
All Hierarchies Enabled, Owned
<Available>
<No Operation>
[ ]
Not installed
Security
X
Boot
InsydeH2O Setup Utility
Rev. 5.0
F1
Help
Esc
Exit
↑/↓
Select Item
←/→
Select Item
F5/F6
Change Values
Enter
Select
X
SubMenu
F9
Setup Defaults
F10
Save and Exit
Selects Power-on state for
Numlock
Numlock
Boot Type
Network Stack
PXE Boot capability
USB Boot
Quiet Boot
Secure Boot Manager
Main
Advanced Security
Exit
<Off>
<UEFI Boot Type>
<Disabled>
<Disabled>
<Enabled>
<Disabled>
Boot
Numlock
Select the power-on state for numlock.
Boot Type
Select the boot type — UEFI Boot Type, Legacy Boot Type or Dual Boot Type.
If you select “UEFI Boot Type” or “Dual Boot Type”, the “Network Stack”, “PXE Boot capability”,
“USB Boot” and “Quiet Boot” will show up.
If you select “Legacy Boot Type”, “PXE Boot to LAN”, “USB Boot” and “Quiet Boot” will show up.
Network Stack
This field is used to enable or disable network stacks, i.e. IPv4 or IPv6 network protocols.
Note:
Please press F10 to save the settings and re-start the system board after changing
"Boot Type".
Note:
The devices shown here are based on a carrier board that may not resemble your
actual carrier board. The actual I/O devices depend entirely on those present on
your actual carrier board.
