DFI CMS630-Q470E, User Manual

Page: 41 / 50

39
Chapter 3
BIOS SETTINGS
User's Manual | CMS630
Debug Configuration
This section configures Debug setting.
Dynamic EFI DEBUG
This field is used to turn on or off the function to output debug message from COM port. When
this field is set to “On”, the following EFI debug configurations will be displayed.
Print Post info message
Informational debug message will be output to COM port.
EFI debug serial port
Enter serial port to output EFI debug message and default is 0x3F8
EFI debug baud rate
Enter the baud rate to output EFI debug message. The default is 115200.
InsydeH2O Setup Utility Rev. 5.0
F1 Help
Esc Exit
↑/↓ Select Item
←/→ Select Item
F5/F6 Change Values
Enter Select
X
SubMenu
F9 Setup Defaults
F10 Save and Exit
Enable it to output debug mes -
sage from COM port.
Debug Configuration
Dynamic EFI DEBUG
Print Post info message
EFI debug serial port
EFI debug baud rate
<On>
<Enabled>
[0x3F8]
[115200]
Advanced
X
Advanced
UEFI Device Manager
Configure UEFI device with option ROM, such as LAN card, etc.
InsydeH2O Setup Utility Rev. 5.0
F1 Help
Esc Exit
↑/↓ Select Item
←/→ Select Item
F5/F6 Change Values
Enter Select
X
SubMenu
F9 Setup Defaults
F10 Save and Exit
UEFI Device Manager Setting
UEFI Device Manager
UEFI Device Manager
Advanced
Exit BIOS Setup Utility and launch Device Manager !!
[OK]
Press “Enter” and “OK” to enter UEFI Device Manager setup page. More device settings can be
configured in the UEFI Device Manager, including LAN, Network Stacks, and etc.
X
Advanced
Note:
Network Device will not be configurable in Device Manager if "Network Stack" is
disabled in the "Boot" menu.