www.d
fi
.com
Chapter 4 BIOS Setup
27
Chapter 4
ACPI Configuration
This section is used to configure ACPI settings.
Enable or Disable the
Wake on Lan
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
Version 2.18.1263. Copyright (C) 2018 American Megatrends, Inc.
Wake On Lan
After G3
Advanced
[Disable]
[Always On]
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Wake On Lan
Enable or Disable this field to use the LAN signal to wake up the system.
After G3
This field is to specify what state the system should be in when power is re-applied
after a power failure (G3, the mechanical-off, state).
Always On
The system is in working state.
Always Off
The system is in soft-off state, except for trickle current to devices such
as the power button.
Note:
If Quiet Boot is set to enabled, BGRT Logo field will appear for configuration. Refer
to the Boot menu for more information.
BGRT Logo
This field is used to enable or disable to support display logo with ACPI Boot Graphics
Resource Table.
Boot Graphics Resource
Table
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
Version 2.18.1263. Copyright (C) 2018 American Megatrends, Inc.
Wake On Lan
After G3
BGRT Logo
Advanced
[Disable]
[Always On]
[Enabled]
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
