25
2
Hardware Installation
SW2 is used to select the front side bus of the CPU installed on
the system board.
Important:
•
Overclocking may result to the CPU’s or system’s instability
and are not guaranteed to provide better system perform-
ance. If you are unable to boot your system due to
overclocking, make sure to set the DIP switch back to its
default settings.
•
To ensure proper boot up and operation of your system, you
must power-off the system then turn off the power supply’s
switch or unplug the AC power cord prior to altering the
setting.
CPU FSB
100MHz
133MHz*
167MHz
200MHz
1
Off
Off
On
On
2
Off
Off
Off
On
3
On
Off
Off
Off
4
Off
Off
On
On
“White” represents the
switch’s position. The exam-
ple on the left shows the
following settings:
pin 1 - Off
pin 2 - Off
pin 3 - Off
pin 4 - Off
2.4.2 Jumper Settings for Selecting the CPU’s FSB (Front
Side Bus)
SW2
X
“*” denotes default setting