46
You may not use IrDA (J2) and the COM 2 serial port (CN2) at the
same time. If you are using the COM 2 serial port, set “Onboard UART
2 Mode” to Standard.
Uses the COM 2 serial port.
HP mode IrDA.
SHARP mode IrDA.
Standard
HPSIR
ASKIR
Onboard Parallel Port
Selects the I/O address and IRQ for the onboard parallel port.
Disables the onboard parallel port.
378H/IRQ7
3BCH/IRQ7
278H/IRQ5
Disabled
Parallel Port Mode
Selects the parallel port mode according to the type of printer
device connected to your onboard parallel port.
SPP
EPP/SPP
ECP
ECP/EPP
Supervisor Password
If you want to protect your system and setup from unauthorized entry,
set a supervisor’s password with the “System” option selected in the
BIOS Features Setup.
If you want to protect access to setup only, but not your system, set a
supervisor’s password with the “Setup” option selected in the BIOS Fea-
tures Setup. You will not be prompted for a password when you cold
boot the system.
USB Controller
By default, the USB controller is Disabled. To use the USB controller,
set this option to Enabled. Refer to the Universal Serial Bus Connectors
section for instructions on connecting the USB ports.
