DFI-ITOX 586ITOX, User Manual

Page: 64 / 91

586ITOX System Board User’s Manual
A
64
3. Detach all connectors from the old system board and remove
expansion cards seated in any expansion slots.
4. Loosen the screws holding the original system board and
remove the board from the system. Save the screws.
5. Remove the I/O shield located at the rear of the system unit
and replace it with the I/O shield included in the package.
Refer to your system chassis manual for instructions on
removing and installing the I/O shield.
6. Remove the system board from its original packing box. Be
careful to avoid touching all connectors and pins on the board.
Please refer to the handling instructions for proper handling
techniques.
7. Insert the memory modules into the memory banks on the
system board. The quantity and location of the memory
modules depends on the memory configuration and type of
modules you intend to use.
8. Install the processor. Be sure pin 1 of the processor is aligned
with pin 1 of the socket.
9. Set the corresponding jumpers.
10. Install the prepared system board into the case and replace the
screws.
11. Reinstall all cards and connectors and replace the system unit
cover. Reconnect all power cords and cables.