11
Troubleshooting Guide
PROBLEM
POSSIBLE CAUSE
SOLUTION
No LCD Display
Batteries not installed
Install batteries
Batteries installed incorrectly
Check polarity matches
Batteries are dead
Replace batteries
LCD Display shown
but no function
No skin contact
Ensure pads are sticky/moist (if not
replace pads), ensure pads are in
contact with the skin.
Unit not connected to
belt correctly
Check that the connecting lead is
fully pushed into output socket.
Intensity level at minimum
Push INT-UP button to increase
intensity. Replace batteries
Batteries are low
Replace batteries
LCD Display not functioning
correctly, all buttons do not
work
Batteries are low
Replace batteries
No stimulation felt
Exhausted battery
Replace batteries
Pads not connected
Check pads are connected
to poppers
Lead not connected
Check lead is firmly pushed
into socket
Defective unit
Contact E-Sculpt
Prickling sensation but no
contraction
Incorrect pad placement
Move the pad/belt until you
feel a stong contraction
Intensity too low
Increase intensity
Gel pad not in good
contact with the skin
Check pads are sticky.
Moisten pads if required.
Maintenance
Disconnect the control unit. Use a damp cloth to wipe clean the control unit and belt.
