9
for example, the rotation speed or the maximum diameter of the cutting wheel, may be
conformity with safety regulations.
TECHNICAL DATA
IMPORTANT INFORMATION
TECHNICAL DATA
EN
EN
MOUNTING THE CUTTING DISC
• Raise the 45° vertical fence approx. 45° and remove.
• Loosen cross-screws with the star-head screwdriver (not supplied) and pull off lower protective
guard.
•
Attach the straight wrench to the hex nut .
•
Use angle wrench to lock the motor shaft.
• Loosen hex nut counter-clockwise using straight wrench.
Nominal voltage
230 V~
Nominal frequency
50 Hz
Nominal power
800 W
Operating mode
S2 : 10 min (short-term operation)
No load speed
3000 min
-1
Weight
14.40 kg
Max. mass of workpiece
10 kg
Max. demensions of workpiece
450 x 380 x 30mm
Diameter of diamond cutting wheel
180 mm
Bore diameter of diamond cutting wheel
22.2 mm
Maximum cutting depth for a 90° cut
30 mm
Maximum cutting depth for a 45° cut
14 mm
Table’s tilting range
0° / 22.5° / 45°
Miter cutter range
0-45°
Protection class
I
Protection type
IP20
WARNING!
This power tool generates an electromagnetic f ield during
under certain circumstances.
To reduce the risk of serious or fatal injuries we recommend that people with
medical implants consult their doctor and the manufacturer of the medical
implant before operating the power tool.
WARNING!
Read
all the safety information and instructions. Failure
to adhere to the safety information and instructions set out below
information and instructions in a safe place for future use.
WARNING!
Pull out the power plug before assembling, adjusting and
changing the cutting disc.
NOTE:
Recommendation for the operator to wear hearing protection.
This machine is designed for operating in S2 mode
(sh
o
rt-term
operation) This means that you
can operate the machine for an uninterrupted period of 10 minutes at most with a nominal load
completely. Afterwards, it can be used again for a maximum of 10 minutes.
BEFORE STARTING THE EQUIPMENT
•
The machine must be set up to a stand or work bench or similar. Before setting up the machine,
choose a stable surface, that is free of obstacles (except materials to be cut) and adequately lit.
•
•
The cutting wheel must rotate smoothly.
•
Check that the
v
oltage on the rating plate is the same as your supply
v
oltage before you connect
the equipment to the power supply.
• Always stand on the front of the machine when operating.
ASSEMBLY AND OPERATION
The noise emission
v
alues were measured in accordance with EN 61029.
Sound
L
pA
sound pressure level
93.5 dB(A)
L
WA
sound power level
103.2 dB(A)
Uncertainty K
K
pA
=3 dB(A);K
WA
=3 dB(A)
