Dexter Power NC500JS, User Manual

Page: 14 / 20

Dexter Power
14
EN
Original Instructions
3. Speed controller
4. Dust extraction tube
5. Tool-less blade clamp
6. Blade guide
7. Shoe plate
8. Hex key
2. SAFETY INSTRUCTIONS
Explanation of symbols
In this manual and/or on the machine the following symbols are may used:
WARNING-To reduce the risk of injure,user must read instruction manual.
Class II machine – Double insulation – You don’t need any earthed plug
Denotes risk of personal injury, loss of life or damage to the tool in case of non-
observance of the instructions in this manual
Indicates electrical shock hazard.
Immediately unplug the plug from the mains electricity in the case that the cord gets damaged and during
maintenance.
Wear eye protection
Wear dust mask
3. ASSEMBLY
To install the blade
Fig.2
WARNING : Always ensure that the jig saw is switched off and plug is removed from the power point before making any
adjustment.
It is recommended to wear protective gloves when inserting or replacing blade.
1. Pull the tool-less blade clamp backwards and hold it.
2. Place the saw blade as far as it will go, ensuring that the blade rear edge is located and supported by the blade roller guide.
3. Release the tool-less blade clamp.
4. Run the jig saw under no load to check that it runs smoothly and the blade is secure before using it to cut any materials
CAUTION: The blade roller guide supports the blade when cutting and must at all times rest against the back edge of the blade.
It should rotate freely.
To remove the blade
Pull the tool-less blade clamp backwards and remove the blade.