8514-238-001 REV PR page 14
RINSE1, RINSE 2, RINSE 3, RINSE 4, and FINAL RINSE.
When “RINSE” is illuminated, up to 4 rinses may be programmed.
Each rinse is shown on the display as “b r1” through “b r4”.
3.1.6
Press “START” to display the settings.
Available settings to alter in each bath are Cycle Time, Water
Temp, Water Level, Type of Fill, Spin Time, and Injection Source.
3.1.7
Input settings.
The first setting to alter is the Cycle Time, shown on the display as
“Ct**” where ** is a placeholder for the options digits. Use the
“DOWN” and “UP” keys to set the desired time in minutes and
press “START” to advance to the next setting. If no change is
desired, press “START” to advance to the next setting. Repeat
process for each setting. Each bath setting can be programmed
with the options shown in Table 5.
SETTING
DISPLAY OPTIONS
Cycle Time
Ct**
Two-digit amount of time for bath in minutes.
-
00 to 15 minutes for Flush, Prewash, Wash,
Rinse 1, 2, 3 and 4. If the time is set to 00,
then the bath will be eliminated from the
cycle.
-
01 to 15 minutes for Final Rinse.
Water
Temperature
t_**
HH for hot water
CH for warm water
CC for cold water
EE for no water
2
Water Level L_**
Lo for low level
HI for high level
Type of Fill
1
dF_*
d for delayed fill (default)
t for timed fill
Spin Time
S_**
Two-digit amount of time for spin in minutes.
-
00 to 10 minutes for Flush, Prewash, Wash,
Rinse 1, 2, 3 and 4
-
01 to 10 minutes for Final Rinse
Injection
Source
2
IS_*
Single-digit code indicating injector signal(s), 0 to 6.
Table 5: Bath Program Settings
1
A delayed fill will pause the cycle time countdown until the selected low level is
reached. A timed fill will allow the cycle time countdown to continue regardless
of water level reached.
2
Codes for injections sources are defined in Table 3. When “EE” is selected in
the Water Temperature setting, the electronic controller prohibits injection
signals. The programmed injection source value is ignored.
3.1.8
To exit the programming of a bath, press the “STOP” button.
If desired, repeat steps 3.1.5 through 3.1.7 to program another
bath.
