8514-238-001 REV PR page 13
3
MACHINE PROGRAMMING INSTRUCTIONS
This Dexter washer is programmed with 6 factory default programs available for
use immediately after installation. Any of these cycles, listed and detailed in
section 3.2, can be customized to include up to 8 baths with various defined
settings including Cycle Time, Water Temperature, Water Level, Type of Fill, Spin
Time, and Injection Source. Programming can be accomplished manually using
the machine
controls or by connecting to the machine control using a PDA
(
P
ersonal
D
igital
A
ssistant). For instructions on using a PDA with this washer
control, please contact your local Dexter laundry equipment distributor. Please
read below for manual programming instructions.
3.1
EDITING AN EXISTING CYCLE
3.1.1
Turn on the power to the washer.
Washer must be in idle mode to program.
3.1.2
Ensure washer is in “PROGRAM” mode.
Locate the “RUN/PROGRAM” key switch and key. The current
mode is indicated by the alignment of the key slot. If washer is not
in “PROGRAM” mode, insert and turn the key to the “PROGRAM”
position.
The display will show “C__0”. The “ADD BLEACH” light will blink
and will continue to blink during the programming mode.
3.1.3
Select cycle to alter.
Press the “DOWN” or “UP” buttons on the keypad, as shown in
Figure 3-1, until the desired cycle number, 01 through 06, is
displayed.
Figure 3-1: Washer Control Keypad Layout
3.1.4
Press “START” to enter the cycle.
The display should now show a “b”.
3.1.5
Select a bath to alter.
Press the “UP” and “DOWN” buttons to select a bath. The mode
indicator lights, as shown in Figure 3-2, illuminate to indicate which
bath is being selected.
FINAL
RINSE
PRE
WASH
FLUSH
WASH
RINSE
SPIN
Figure 3-2: Washer Mode Lights
There are 8 available baths to program: FLUSH, PREWASH, WASH,
