MWP141-P1M 27MHz Wireless Optical Mouse page 4 of 8
1.0 Edition
Synchronize the RF Mouse (Pairing)
If the mouse is in sleep mode click the mouse button once to wake it up.
1.
Bring the mouse within 1 ft range from the receiver.
2.
Power on the mouse.
3.
Hold the mouse upside-down and use a pointed object, such as a pen tip, to click the
CONNECT button (ID button) once.
4.
Click the receiver’s connect button once, within 5 seconds after clicking the connect
button on the mouse. The LED will start blinking, when the connection is established.
Move the mouse around to test if it was successful.
5.
If the synchronization is not successful for some reason please
a.
Remove the batteries and unplug the receivers
b.
Wait for 20 sec then to try the step 1 to 4 again
Note: * During normal use, please make sure that the mouse is no more than 3 ft away from the receiver
in order to have reliable connection.
** The LED on the receiver will light up or blink while the mouse is being used
Operation Guide
BATTERY LOW INDICATION
When battery voltage level goes under the preset level, the receiver LED will blink
frequency. Although the mouse can still work for a while, the user, at this time, should have a
new set of batteries ready for replacement as soon as possible.
POWER ON/OFF MOUSE
MWP141-P1M designed 2 methods for power saving, you can power ON/OFF by A or B.
A.
The MWP141-P1M mouse is designed to automatically turn off when you store the
wireless USB receiver in its bottom. Release the receiver from the bottom to power on.
B.
By pushing right, left & scroll wheel to power off, click any button to power on.
OPERATIONS ON POWER SAVING MODE:
In order to conserve battery power, the mouse is designed to reduce power consumption
