4
ID channels for both receiver and mouse.
Please follow the steps as below to set up:
1. Turn to the bottom of the
receiver and you will see
a small rectangular hole
(take the cover as Fig-2.1)
and a slide switch
(channel selection,
refer to Fig-2.2).
2. The carrier channel is set by a slide switch with A or B
positions. Make sure the switches have the same
setting as the mouse, as following descriptions (refer
the right Fig-2.3, it is pre-set at factory).
3. Establish communication between the receiver and the
mouse (select identification codes).
Press and release the connect button on bottom of
the wireless mouse (refer to Fig-3.1).
Press and release the connect button on the
receiver (refer to Fig-3.2).
The "connect" light on the top dome of receiver will
flash while the same ID is selected on both of the
receiver and the mouse.
Step 3. Installing the Batteries
This RF wireless mouse uses 2 AA batteries. To apply the
batteries, please follow the steps as below:
1. Turn the mouse to the bottom side
2. Remove the batteries cover by moving the opening
tabs and pull the battery cover (the top cover of the
mouse) out
3. There are signs to indicate batteries' positive and
negative poles. Follow the signs to place the batteries
4. Place the batteries cover back and make sure it is firmly closed
Fig-2.1
Fig-
Fig-2.3
Fig-3.1
Fig-3.2
