8
9
EN
EN
EN
EN
LIST OF STANDARDS
The DEWALT
®
TSTAK
®
CONNECT RADIO + CHARGER complies with the following standards:
•
ANSI/UL60065:2015 Ed.8
•
CAN/CSA-C22.2 No. 60065:2016 Ed.2
•
ANSI/UL1310 (6th Edition rev. December
12, 2014)
•
CSA C22.2 No.223-M91 (Rev. September 2013)
•
IC RSS210: Issue 9: 2016
•
ICES-003, Issue 6: 2016
•
UL 2595:2015 Ed.2
•
FCC part 15 Certification: 2016 (ANSI
C63.10 :2013)
•
FCC ID: YJ7DWST17510
•
IC: 9082A-DWST17510
FCC
1.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1). This device may not cause harmful interference, and
(2). This device must accept any interference received, including interference that may cause
undesired operation.
2.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
3.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment to an outlet on a circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
WARNING:
To reduce the risk of fire or electric shock,
DO NOT
expose this appliance to
direct rain or moisture. Use only in dry locations.
WARNING:
To prevent electric shock, match the wide blade of the adaptor plug to the wide
slot of the outlet and fully insert.
LIST OF SYMBOLS
The labels on this appliance may include the following symbols:
V Volts
A Amperes
W Watts
h hours
Direct current
Class II Construction
(double insulated)
Hz hertz
min minutes
Class II Construction (double insulated)
ETL Testing Laboratories symbol
Safety alert symbol
Read all documentation
BATTERIES AND CHARGERS
The battery pack is not fully charged out of the carton. Before using the battery pack and charger,
read the safety instructions below and then follow charging procedures outlined.
When ordering replacement battery packs, be sure to include the catalog number and voltage. The
TSTAK
®
CONNECT RADIO + CHARGER is to be used only with DEWALT
®
DCB series 12VDC/20VDC
Li-ion rechargeable battery packs, including DEWALT
®
XR
®
FLEXVOLT
®
battery packs of up to 9Ah.
Use of any other battery packs or any non-rechargeable batteries may create a risk of injury or fire.
Your radio is a DEWALT charger. Be sure to read all safety instructions before using your charger.
Recharge only with the TSTAK
®
CONNECT RADIO integrated charger, or equivalent. A charger that is
suitable for one type of battery pack may create a risk of fire when used with another battery pack.
READ ALL INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS FOR ALL BATTERY PACKS
WARNING:
Read all safety warnings and all instructions for the battery pack, charger and
power tool. Failure to follow the warnings and instructions may result in electric shock, fire
and/ or serious injury.
•
Do not charge or use the battery pack in explosive atmospheres, such as in the
presence of flammable liquids, gases or dust
. Inserting or removing the battery pack
from the charger may ignite the dust or fumes.
•
NEVER force the battery pack into the charger. DO NOT modify the battery pack in any
way to fit into a non-compatible charger as battery pack may rupture causing serious
personal injury.
•
Charge the battery packs only in designated DEWALT
®
chargers.
•
DO NOT splash or immerse in water or other liquids.
•
Do not store or use the appliance and battery pack in locations where the temperature
may reach or exceed 104°F (40°C) (such as outside sheds or metal buildings in summer)
.
For best life store battery packs in a cool, dry location.
NOTE:
Do not store the battery packs in a tool with the trigger switch locked on. Never tape
the trigger switch in the ON position.
•
The AC/DC adaptor shall not be exposed to dripping or splashing, and no objects filled with
liquids, such as vases, shall be placed on apparatus.
WARNING:
Fire hazard. Never attempt to open the battery pack for any reason.
If the battery pack case is cracked or damaged, do not insert into the charger. Do not crush,
drop or damage the battery pack. Do not use a battery pack or charger that has received
a sharp blow, been dropped, run over or damaged in any way (e.g., pierced with a nail, hit
with a hammer, stepped on). Damaged battery packs should be returned to the service
center for recycling.
