2. Sequential Triggering:
allows “place nailing” without the
possibility of driving a second, unwanted fastener on recoil.
D
E
WALT offers only one mode of operation with this tool.
NOTE:
This tool operates sequentially, it’s operation is unique from
all other D
E
WALT tools. The moveable nose (D), which acts as the
contact trip, is in the “depressed” position at rest to allow visibility of
the nail points used for positive placement. When the tip of the nail is
placed in the preformed metal connector hole (G) and the trigger is
pulled, the moveable nose moves out from the tool to detect the work
surface. If the moveable nose does not detect the work surface close
to the nose of the tool, the tool will not actuate.
WARNING:
To avoid serious injury from fasteners and flying debris
when installing metal connectors using the mcn nailer:
•
Use only genuine D
E
WALT metal connector nails.
•
Metal connector nails are not designed to penetrate metal. When
installing metal connectors, always place the exposed point of
the metal connector nail into the metal connector’s pre-formed
hole, and orient so the nail is perpendicular to the hole before
attempting to drive a fastener.
FIG. 4
CORRECT
PLACEMENT OF NAIL
INCORRECT
PLACEMENT OF NAIL
G
TO DRIVE A FASTENER (FIG. 1, 4)
Place the tip of the nail into the metal connectors preformed hole (G),
while holding the moveable nose (the “trip”) FULLY against the work
surface then, pull the trigger (A).
To drive a second nail the operator must lift the tool from the work
surface, release the trigger and then repeat the sequence.
Tool Operation Check (Fig.1)
WARNING:
Remove all fasteners from tool before performing tool
operation check.
SEQUENTIAL TRIGGERING OPERATION:
A. Press the moveable nose against the work surface, without
touching the trigger (A).
THE TOOL MUST NOT CYCLE.
B. Hold the tool off the work surface and pull the trigger.
THE TOOL MUST NOT CYCLE.
Release the trigger. The trigger must return to the trigger stop on
the frame.
C. Pull the trigger and press the moveable nose against the work
surface.
THE TOOL MUST NOT CYCLE.
D. With finger off the trigger, press the moveable nose against the
work surface. Pull the trigger.
THE TOOL MUST CYCLE.
Loading the Tool (Fig. 1, 5)
WARNING:
Keep tool pointed in a safe direction when loading
nails.
WARNING:
Never load nails with the contact trip or trigger
activated.
WARNING:
Never mix different length nails in the magazine.
English
7
