ENGLISH
7
INTENDED USE
Your
DW862
tile cutter has been designed for
professional tile cutting.
DO NOT
use in wood or metal cutting applications.
Do not use steel tooth blades or tungsten tipped
tooth blades for wood or metal cutting.
WARNING:
Wheels must be used only for
recommended applications.
The
DW862
tile cutter is a professional power tool.
DO NOT
let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your
D
e
WALT
tool is double insulated;
therefore no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D
e
WALT
service organisation.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see
Technical Data
).The minimum
conductor size is 1.5 mm
2
; the maximum length
is 30 m.
When using a cable reel, always unwind the cable
completely.
Connecting to the Mains
The mains supply to be used for this machine must
be equipped with a 16 A cut-out fuse with time delay.
Voltage Drops
Inrush currents cause short-time voltage drops.
Under unfavourable power supply conditions, other
equipment may be affected.
If the system impedance of the power supply is lower
than
0.11
Ω, disturbances are unlikely to occur.
POWER SUPPLY
Be sure your power supply agrees with the
nameplate marking. A voltage decrease of more than
10% will cause a loss of power and overheating.
Switching On And Off (fig. 1)
• To switch the tool on, press the on/off switch(1).
• To switch the tool off, release the on/off switch.
• This tool has a lock-on feature. To activate press the on/
off switch and the then lock-on button (2). To de-activate
press the on/off switch button again.
• Always switch off the tool when work is finished and
before unplugging.
Assembly and adjustments
WARNING:
To reduce the risk of injury, turn
unit off and disconnect tool from power source
before installing and removing accessories,
before making any adjustments or removing/
installing attachments or accessories.
An
accidental start-up can cause injury.
WARNING:
Prior to assembly and adjustment,
always unplug tool.
To Install the Diamond Blade (Fig. 2)
1. Place saw on a stable surface.
2. Place blade (D) on spindle.
3. Using the flange wrench provided, hold the
external flange (E)
4. Turn the clamping screw (F) counterclockwise to
tighten. Use the hex wrench provided to secure
tightly.
5. To remove the blade, reverse this procedure.
WARNING:
Use only diamond cut-off wheels
for your power tool.
OPERATION
WARNING:
Always observe the safety
instructions and applicable regulations.
WARNING:
To reduce the risk of injury, turn
unit off and disconnect tool from power source
before installing and removing accessories,
Summary of Contents for DW862
Page 1: ...DW862 ...
Page 60: ...N424950 01 2015 ...
