English
STEP 17. Parallel the rear rail to the table top (Fig. 6).
Using your fence face or a straightedge to extend the
table surface over the rail, make sure the distance from
the table top to the rail top is the same at both the left
and right side of the table. If the rail is not aligned cor-
rectly, loosen the hardware slightly and tap on the rail
with a soft hammer or a regular hammer and a block of
wood until the distances are the same. Tighten the
hardware securely. Repeat procedure to parallel rear
rail to accessories (if applicable).
STEP 18. Parallel the rear rail to support table(s)
(Fig. 7). Using your fence face as a straightedge, make
sure the rear outer corner of the support table is level
with the inner edge and main table surface. Adjust if
necessary and tighten hardware. Repeat this proce-
dure for the other support table (if applicable).
STEP 19. Assemble the outfeed table (Fig. 11).
You will need: 2 - 10 x 25mm hex head bolts
2 - 10mm flat washers
2 - 10mm lock washers
2 - 10mm nuts
Place the table on the floor, flat side down. Mount the two
remaining hanger brackets using two M10 x 25 bolts.
Secure each bolt through the square hole in the short
leg of the bracket with a flat washer, lock washer, and
nut (Fig 11). Tighten snug only.
STEP 16. Position rear rail as shown and attach (Fig. 10).
You will need: 4 - 10 x 35mm hex head bolts
4 - 10mm flat washers
4 - 10mm lock washers
4 - 10mm nuts
TABLE
REAR SUPPORT
BRACKET
INVERTED
REAR RAIL
FIG. 10
STEP 20. Unfold the leg set by depressing the locking
buttons on both sides and swinging the leg set upward
until the locking buttons engage.
STEP 21. Place the outfeed table into position (Fig. 12).
You will need: 2 - 10mm carriage bolts
2 - 10mm wing nuts
Position table so the hanger brackets on the outfeed
table are on top of the brackets on the table saw. Place
the carriage bolts down through the square holes in
the brackets and secure each with a wing nut. Tighten
securely.
FIG. 11
FIG. 12
STEP 22. Check Outfeed Table miter clearance slot
alignment. Place miter gauge into right hand miter slot
in the saw table. Slide miter gauge beyond the rear of
the saw table and into the clearance slot in the Outfeed
Table top. Outfeed Table should not interfere with the
smooth operation of the miter gauge. If necessary,
loosen the M10 x 25 hardware (Fig. 13) holding the
table to the hanger brackets and tap on the outfeed
table with a soft hammer or a regular hammer and a
block of wood until clearance slot is aligned.
STEP 23. Parallel outfeed table to the table top.
Outfeed table should be level with or slightly below the
table top. For the edge closest to the table use your
fence face or a straightedge to extend the saw table
surface over the outfeed table. To align the tables tap
on the outfeed table with a soft hammer or a regular
hammer and a block of wood until they are parallel.
Tighten the M10 X 25 hardware holding the outfeed
table to the hanger brackets securely (Fig. 14). Using
the adjustable feet on the bottom of the leg set, level
the rear of the outfeed table to match its front edge.
FIG. 13
STEP 24. See DW746 manual for Table Saw operating
instruction and adjustments.
FIG. 14