DeWalt DCN623, Instruction Manual

Page: 13 / 44

11
English
Three Year Limited Warranty
For warranty terms, go to https:// www.dewalt.com /Legal/
Warranty/3-Year-Limited-Warranty.
To request a written copy of the warranty terms, contact:
Customer Service at
D
e
WALT Industrial Tool Co., 701 East
Joppa Road, Towson, MD 21286 or call 1-800-4- D
e
WALT
( 1‑800‑433‑9258 ).
lATin AMERiCA: This warranty does not apply to products
sold in Latin America. For products sold in Latin America,
see country specific warranty information contained in
the packaging, call the local company or see website for
warranty information.
FREE WARning lABEl REPlACEMEnT: If your warning
labels become illegible or are missing, call 1-800-4- D
e
WALT
( 1‑800‑433‑9258 ) for a free replacement.
• FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
• Register online at www.dewalt.com .
Repairs
The charger and battery pack are not serviceable. There are
no serviceable parts inside the charger or battery pack.
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement, when
applicable) should be performed by a
D
e
WALT factory
service center or a D
e
WALT authorized service center.
Always use identical replacement parts.
Accessories
WARNING: Since accessories, other than those
offered by D
e
WALT , have not been tested with this
product, use of such accessories with this product
could be hazardous. To reduce the risk of injury, only
D
e
WALT recommended accessories should be used
with this product.
Recommended accessories for use with your product are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact
D
e
WALT call 1-800-4- D
e
WALT
( 1‑800‑433‑9258 ) or visit our website: www.dewalt.com .
Cleaning the Driver Path (Fig. A, G)
Glue from the pin strip may need to be cleaned from the
driver path if the tool will not drive pins properly.
1. Remove the battery pack 1 .
2. Remove the pin strip from the tool.
3. Open the tool free jam release (refer to
To Clear a
Jammed Pin .
4. Apply a small amount of tool oil on a clean cloth and
wipe down the pin channel until any glue is removed.
5. Reinstall the drive cover.
6. Insert a pin strip and reinstall the battery.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non‑metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Register Online
Thank you for your purchase. Register your product now for:
• WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
• COnFiRMATiOn OF OWnERshiP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.