DeWalt DCL510-XE, Instruction Manual

Page: 11 / 20

9
Camera Cable (Fig. 5)
Align the camera cable with the camera connector (D). Push in and turn the connector
counterclockwise (camera screen facing you) to firmly attach.
D
FIG. 5
To remove the camera cable, turn the connector clockwise (direction of arrow).
Additional camera cable and extensions are available at additional cost. Please contact
Stanley Black & Decker, 82 Taryn Drive, Epping, VIC 3076 Australia or call 1800 444
224 or (NZ). 0800 339 258.
Hook and Magnet
FIG. 6A
T
U
V
(Fig. 6)
The hook is beneficial for retrieving cable or
wire located in tight spaces. The magnet is
beneficial for retrieving metal objects in tight
spaces.
To attach the hook or magnet, turn the
knurled part of the camera counterclockwise
until it stops.
Align the hook or magnet with the
gray groove (T) then slide it down until the
tabs (U) at the top of the hook/magnet are
FIG. 6B
securely in the notches (V) located in the
camera lens.
Turn the knurled part clockwise to lock the
base of the hook and magnet.
Belt Hook (Fig. 7) (Optional Accessory)
WARNING: To reduce the risk of serious personal injury, DO NOT suspend tool
overhead or suspend objects from the belt hook. ONLY hang tool’s belt hook from a
work belt.
WARNING: To reduce the risk of serious personal injury, ensure the screw (W)
holding the belt hook is secure.
IMPORTANT:
When attaching or removing the belt hook, use only the screw (W) that
is provided.
The belt hook (X) can be be attached
W
X
FIG. 7
to either side of the tool using only the
screw (W) provided, to accommodate
left- or right- handed users. If the hook
is not desired at all, it can be removed
from the tool.
To move belt hook, remove the screw
(W) that holds the belt hook in place
then reassemble on the opposite side.
OPERATION
Installing and Removing the Battery Pack (Fig. 8)
NOTE: Make sure your battery pack is fully charged.
To install the battery pack (A) into the tool handle, align the battery with the rails
inside the tool’s handle and slide it firmly into the handle until you hear the lock snap
into place.
FIG. 8
Y
A
To remove the battery pack from the tool, press the release button (Y) and firmly pull
the battery pack out of the tool handle. Insert it into the charger as described in the
charger section of this manual.