23
EnGLIsh
Protecting the Environment
w
Separate collection. Products marked with this symbol must not be disposed of
with normal household waste.
Products contain materials that can be recovered or recycled reducing the demand
for raw materials. Please recycle electrical products according to local provisions.
Further information is available at
www.2helpU.com
.
Storage
Store the equipment and accessories out of children's reach in a dark and dry place at above
freezing temperature. The ideal storage temperature is between 5 °C and 30 °C.
Stand
D240001 Heavy Duty Tile Saw Stand
Range of Cutting Discs Available
DT3734
Wet tile diamond saw blade for cutting ceramic, porcelain tiles and stone
DT3733
Wet tile diamond saw blade for cutting tiles
Optional Accessories
WARNING:
Since accessories, other than those offered by
D
e
WALT
, have not been tested
with this product, use of such accessories with this tool could be hazardous. To reduce the
risk of injury, only
D
e
WALT
recommended accessories should be used with this product.
Consult your dealer for further information on the appropriate accessories.
Before use, carefully check the cutting disk cover to determine that it will operate properly.
Ensure that mud, or work‑piece particles cannot lead to blockage of one of the functions.
In case of workpiece fragments jammed between cutting disc and guard disconnect the
machine from the power supply and follow the instructions given in section
Mounting the
cutting disc
. Remove the jammed parts and reassembling the cutting disc.
Keep the ventilation slots clear and regularly clean the housing with a soft cloth.
The following cleaning operations must be performed every day.
1. Insert the water pump into a bucket of clean water and pump the water through the
hose system.
2. Wipe the rails and support arm with a grout sponge or a rag.
3. Spray the water basin and the sliding table with clear water. Wipe any dust residue away
with a grout sponge.
D
Cleaning
WARNING:
Blow dirt and dust out of the main housing with dry air as often as dirt is seen
collecting in and around the air vents. Wear approved eye protection and approved dust
mask when performing this procedure.
WARNING:
Never use solvents or other harsh chemicals for cleaning the non-metallic
parts of the tool. These chemicals may weaken the materials used in these parts. Use a
cloth dampened only with water and mild soap. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
C
Lubrication
Your power tool requires no additional lubrication.
Draining the Water Basin (Fig. Z)
The water basin must be drained after each use.
1. Place a suitable container under the drain plug
58
.
2. Remove the drain plug.
3. Allow ample time for the liquid to drain.
4. After the liquid has been drained, re‑install the drain plug.
5. Dispose of the liquid with due care for the environment.
MAINTENANCE
Your power tool has been designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends upon proper tool care and
regular cleaning.
WARNING:
To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories.
An accidental start-up can cause injury.
WARNING:
To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment should be performed by a
D
e
WALT
factory service centre or a
D
e
WALT
authorized service centre. Always use identical replacement parts.
If the supply cord is damaged, it must be replaced only by
D
e
WALT
or an authorised
service organisation.
Summary of Contents for D36000
Page 1: ...D36000 ...
Page 6: ...4 Fig T Fig V Fig X Fig Z Fig Y Fig U Fig W 25 59 58 9 8 13 12 15 19 37 ...
Page 87: ......
