DeWalt D28803, Instruction Manual

Page: 11 / 32

11
SURFACE GRINDING WITH GRINDING WHEELS
1. Allow the tool to reach full speed before touching the tool to the
work surface.
2. Apply minimum pressure to the work surface, allowing the tool
to operate at high speed. Grinding rate is greatest when the tool
operates at high speed.
3. Maintain a 20˚ to 30˚ angle between the
tool and work surface.
4. Continuously move the tool in a forward
and back motion to avoid creating
gouges in the work surface.
5. Remove the tool from work surface before turning tool off. Allow
the tool to stop rotating before laying it down.
EDGE GRINDING WITH GRINDING WHEELS
CAUTION:Wheels used for cutting and edge grinding may break
if they bend or twist while the tool is being used to do cut-off work or
deep grinding.To reduce the risk of serious injury, limit the use of
1. Backing flange is retained to the grinder by an O-ring on the
spindle. Remove backing flange by pulling and twisting flange
away form the machine.
2. Thread the wheel on the spindle by hand.
3. Depress the spindle lock button and use a wrench to tighten the
hub of the wheel.
4. Reverse the above procedure to remove the wheel.
CAUTION: Failure to properlyseat the wheel before turning the
tool on may result in damage to the tool or the wheel.
MOUNTING NON-HUBBED WHEELS
CAUTION: Turn off and unplug the tool before making any
adjustments or removing or installing attachments or acces-
sories. Before reconnecting the tool, turn the switch on and off
as previously described to ensure that the tool is off.
Depressed center Type 27 grinding wheels
must be used with included flanges. See
page 6 of this manual for more information.
1. Install the unthreaded backing flange
(G) on spindle (D) with the raised section
(pilot) against the wheel. Be sure the
backing flange recess is seated onto the flats of the spindle by
pushing and twisting the flange before placing wheel.
2. Place wheel against the backing flange,
centering the wheel on the raised sec-
tion (pilot) of the backing flange.
3. While depressing the spindle lock but-
ton, thread the clamp nut (H) on spin-
dle. If the wheel you are installing is
more than 1/8" (3.31mm) thick, place
the threaded clamp nut on the spindle
so that the raised section (pilot) fits into
the center of the wheel. If the wheel you
are installing is 1/8" (3.31mm) thick or
1/4" WHEELS
(6.35mm)
Clamp Nut
less, place the threaded clamp nut on
the spindle so that the raised section
(pilot) is not against the wheel.
4. While depressing the spindle lock button,
tighten the clamp nut with a wrench.
5. To remove the wheel, depress the spin-
dle lock button and loosen the threaded
clamp nut with a wrench.
NOTE:
If the wheel spins after the clamp nut
is tightened, check the orientation of the
threaded clamp nut. If a thin wheel is
installed with the pilot on the clamp nut
against the wheel, it will spin because the
height of the pilot prevents the clamp nut
from holding the wheel.
1/8" WHEELS
(3.31mm)
Backing Flange
Backing Flange
Clamp Nut
H
G
D
20°-30°
E
n
g
lis
h