DeWalt D28413, Original Instructions Manual

Page: 10 / 20

ENGLISH
8
Description (Fig. 1, 4)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
A. On Off Trigger
B. Lock On Button
C. Spindle Lock
E. Wheel Guard
F. Spindle
G. Side handle
I. Two Pin Spanner
J. Backing Flange
K. Threaded Clamp Nut
INTENDED USE
Your heavy-duty angle grinder has been designed
for professional grinding, sanding, wire brush and
cutting.
DO NOT use under wet conditions or in the
presence of flammable liquids or gases.
These heavy-duty angle grinders are professional
power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D
e
WALT tool is double insulated in
accordance with EN60745; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D
e
WALT service organisation.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. If an extension cable is
required, use an approved 3–core extension
cable suitable for the power input of this tool (see
Technical Data ).The minimum conductor size is
1.5 mm
2
; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Before
reconnecting the tool, depress and
release the trigger switch to ensure that
the tool is off.
Attaching Side Handle (Fig. 2)
WARNING:
Before using the tool,
check that the handle is tightened
securely.
WARNING: The side handle should
always be used to maintain control of
the tool at all times.
Screw the side handle (G) tightly into one of the
holes (M) on either side of the gear case.
Mounting and Removing a Keyed
Guard (Fig. 1, 3)
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Before
reconnecting the tool, depress and
release the trigger switch to ensure that
the tool is off.
CAUTION:
Guards must be used with
this grinder.
When using the grinder for cutting metal or masonry
a Type 1 guard MUST be used. Type 1 guards are
available at extra cost from D
e
WALT distributors.
NOTE: Please refer to the Grinding and Cutting
Accessory Chart at the end of this section to
show other accessories that can be used with these
grinders.