DeWalt D26204-XE, Instruction Manual

Page: 11 / 20

9
5. While holding down on the cone, tighten the subbase screws.
LL
LL
T
FIG. 6A
FIXED BASE
FIG 6B
LL
LL
PLUNGE BASE
T
Using Template Guides
The plunge subbase will accept template guides. On the fixed base an accessory
subbase will be needed to accept template guides. Recommended accessories for
use with your tool are available at extra cost from your local dealer or authorised
service center.
NOTE: The D-shape subbase does not accommodate template guides and is designed
to accommodate cutters up to 30 mm in diameter.
TO USE TEMPLATE GUIDES
1. Install template guide to subbase using two screws and tighten securely.
2. Center the subbase. Refer to
Centering the Subbase .
Adjusting the Depth of Cut (Fixed Base Only, Fig. 1, 7)
WARNING: To reduce the risk of injury, turn unit off and disconnect it from
power source before installing and removing accessories, before adjusting or
when making repairs. An accidental start-up can cause injury.
1. Select and install the desired cutter. Refer to Cutter Installation and Removal .
2. Assemble fixed base to motor (J), ensuring base is attached to the depth
adjustment ring (B). Place router on the work piece.
3. Open the locking lever (I) and turn the depth adjustment ring (B) until the cutter
just touches the work piece. Turning the ring clockwise raises the cutting head
while turning it counterclockwise lowers the cutting head.
4. Turn the micro adjustable scale (H) clockwise until the 0 on the scale lines up
with the pointer on the bottom of the depth adjustment ring.
5. Turn the depth adjustment ring until the pointer lines up with desired depth of cut
marking on the micro adjustable scale.
NOTE: Each mark on the adjustable scale represents a depth change of 0.5 mm
and one full (360º) turn of the ring changes the depth 12.7 mm.
6. Close the locking lever (I) to lock the base.
B
H
I
B
H
FIG. 7