DeWalt D25820, Original Instructions Manual

Page: 16 / 64

14
EngLIsh
OPERATION
Instructions for Use
WARNING: Always observe the safety instructions and
applicable regulations.
WARNING: To reduce the risk of serious personal injury, turn
tool off and disconnect tool from power source before making
any adjustments or removing/installing attachments or
accessories.
Be sure the trigger switch is in the OFF position. An
accidental start‑up can cause injury.
WARNING:
• Be aware of the location of pipework and wiring.
• Apply only a gentle pressure to the tool (approximately 20 kg).
Excessive force does not speed up drilling but decreases tool
performance and may shorten tool life.
• Always hold the tool firmly with both hands and ensure a
secure stance. Always operate the tool with the side handle
properly assembled.
nOtE:
Operating temperature is -7 ˚ to +40 ˚C. Using the tool outside of
this temperature range will decrease the life of the tool.
Proper Hand Position (Fig. E)
WARNING: To reduce the risk of serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of serious personal injury, ALWAYS hold
securely in anticipation of a sudden reaction.
Proper hand position requires one hand on the side handle
3
, with the
other hand on the main handle
4
.
Switching On and Off (Fig. A)
To turn the tool on, press the on/off rocker switch 1 at the lower part of
the trigger.
To stop the tool, press the on/off rocker switch at the upper part of
the trigger.
Chipping and Chiselling (Fig. A)
1. Insert the appropriate chisel and rotate it by hand to lock it into one of
18 positions.
2. Set the mode selector switch
5
to the hammering only position.
3. Fit and adjust the side handle 3 .
4. Turn the tool on and start working.
5. Always turn the tool off when work is finished and before unplugging.
MAINTENANCE
Your D
e
WALT power tool has been designed to operate over a long period
of time with a minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of serious personal injury, turn
tool off and disconnect tool from power source before making
any adjustments or removing/installing attachments or
accessories.
Be sure the trigger switch is in the OFF position. An
accidental start‑up can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING:
Blow dirt and dust out of the main housing with dry air
as often as dirt is seen collecting in and around the air vents. Wear
approved eye protection and approved dust mask when performing
this procedure.
WARNING: Never use solvents or other harsh chemicals for cleaning
the non‑metallic parts of the tool. These chemicals may weaken the
materials used in these parts. Use a cloth dampened only with water
and mild soap. Never let any liquid get inside the tool; never immerse
any part of the tool into a liquid.
Optional Accessories
WARNING: Since accessories, other than those offered by D
e
WALT ,
have not been tested with this product, use of such accessories with
this tool could be hazardous. To reduce the risk of injury, only
D
e
WALT
recommended accessories should be used with this product.
Consult your dealer for further information on the appropriate accessories.
Protecting the Environment
Separate collection. Products and batteries marked with this
symbol must not be disposed of with normal household waste.
Products and batteries contain materials that can be recovered or
recycled reducing the demand for raw materials. Please recycle
electrical products and batteries according to local provisions. Further
information is available at
www.2helpU.com
.