DeVilbiss SRiPro Lite Micro, Service Manual

Page: 10 / 72

EN
- see over page
(reverse for assembly)
KEY
- see over page
To clean air cap and fluid tip, brush exterior with a stiff bristle brush. If necessary to clean cap holes,
use a broom straw or toothpick if possible. If a wire or hard instrument is used, extreme care must
be taken to prevent scratching or burring of the holes which will cause a distorted spray pattern.
Depending on hose length, larger I.D. hose may be required. Install an air gauge at the gun handle.
When gun is triggered on, adjust regulated pressure as required. Do not use more pressure than is
necessary to atomize the material being applied. Excess pressure will create additional overspray and
reduce transfer efficiency.
NOTE
If quick connect couplings are required, use only high flow quick connects. Other types will not flow
enough air for correct gun operation.
To clean fluid passages, remove excess material, then flush with gun wash solution. Wipe the gun
exterior with a dampened cloth. Never completely immerse in any solvent or cleaning solutions as
this is detrimental to the lubricants and life of the spray gun.
Order for disassembly
SPRAY GUN MAINTENANCE & CLEANING
SPRAY GUN DISASSEMBLY / ASSEMBLY
(reverse for assembly)
NOTE
#
#
SB-2-512 R1
10/24
www.carlisleft.com