E-5
11. Move the stopper up and down to confirm that
the stopper’s light blocking plate does not touch
the inner surfaces of the sensor slit.
* In case of <NG>, take the following step.
(1) Raise the stopper and loosen the screw that
holds the sensor mounting plate.
(2) To make the light blocking plate pass the cen-
ter of the sensor slit, move the sensor mount-
ing plate from side to side and adjust the
mounting plate’s position.
(3) Lower the stopper and confirm that the state is
that of <OK>.
A10DIXC061DA
Stopper
Sensor
Light blocking
plate
Sensor slit
< OK >
< NG >
< NG >
A10DIXC058DA
A10DIXC059DA
A10DIXC060DA
(4) Raise the stopper again and tighten the screw
that was loosened in step (1).
(5) Lower the stopper again and confirm newly
that the state is that of <OK>.
12. Pull the right rail out completely.
13. Attach the saddle unit to the rails (one screw).
Note:
Use the screw removed in step 5.
14. Slide the saddle unit in the finisher and close the
front door of the finisher.
15. Make copies again and check the crease posi-
tions deviate.
16. After completing the adjustment, secure the rail
of the saddle unit (one screw).
Note:
• Use the screw removed in step 4.
• Before securing the rail, make sure that the pro-
jection on the rail is on the back side of the
screw hole.
A10DIXC058DA
A10DIXC046DA
A10DIXC047DA
A10DIXC041DA
A10DIXC022DA
< OK >
< NG >
Projection
