E-2
7. Remove the covers from the finisher (right and
left) as shown below (two screws).
8. Remove the three screws inside the finisher and
remove the plate from the finisher as shown
below.
Note:
• Remove the screws located at the ends first.
• While holding the plate in position, remove the
screw located at the center.
9. Attach the left and right rails furnished with the
saddle stitcher (two screw A’s furnished with the
saddle stitcher each).
Note:
• To align the screw holes, use the below as a
guide.
<Rail (Left)>
Put the rear end of the rail about 45 mm from
the back of the finisher.
<Rail (Right)>
Make the front end of the rail protrude about
10 mm from the finisher front plate.
• Put the rail along downward to screw.
10. Pull the left rail out completely.
A10DIXC011DA
A10DIXC012DA
A10DIXC014DA
< Right >
< Left >
A10DIXC013DC
45 mm
10 mm
With hooks
11. Grip the portion as shown in the illustration
below to raise the saddle unit. Insert the two
hooks on the left rail into the two holes on the
saddle unit.
12. Pull the right rail out completely.
13. Attach the saddle unit to the rails (one screw A
furnished with the saddle stitcher each for left
and right).
14. Use the mark as a reference to insert the two
pantograph hooks of the saddle unit into the
back hole locating inside of the finisher.
15. Secure the pantograph (one screw B furnished
with the saddle stitcher).
16. Connect the three pantograph connectors to the
finisher, and gather the harness into the wire
saddle.
A10DIXC015DB
A10DIXC017DA
A10DIXC019DA
A10DIXC020DA
A10DIXC023DA
Mark
A10DIXC024DA
A10DIXC025DA
Connector
Wire saddle
