- 8 -
screen, and the ice making time for next cycles will be one minutes more.
For example, if LED flashes 10, at this time, you press , data 1 will be soon on the
screen, means next cycles, the ice harvest will count down from 11minutes. If two presses are
done, then count down from 12minutes.
Step 6 Auto clean function: before the unit is turned on, long press the TIMER/CLEAN button for
3seconds, unit will enter the auto clean mode.
Step 7 Press button ON/OFF again to turn unit off.
Caring
1.Clean the inner liner, water box, ice shovel and evaporator frequently. When cleaning, unplug
the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the
inside and the outside surface of the Ice maker. Do not spray Ice maker with chemicals or
diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.
2.Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of
obstruction. Do not use mechanical devices or other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
3.If the machine is reused after a long time, maybe the water pump cannot pump sufficient water
due to the air inside, the ADD WATER water indicator light will turn on in this case. To correct
this, press the START button again, then the machine will work normally.
4.To ensure the cleanliness of the ice cubes, water in the water reservoir should be replaced
every 24 hours.
5.If the compressor stops for any reason such as water shortage, too much Ice, power off, etc...
Do not start the system right away, wait 3 minutes, and then re-start the Ice maker.
6.Always change with fresh water before starting ice production at initial installation or after long
shut-off periods.
Troubleshooting
1. Please note, if the water filled to the evaporator is not symmetrical, small sundries maybe be
formed and lodged in the pipe which will mean that water will be filled to the evaporator causing
it to jam.
2. Please pull out the cap of the pipe, then let the water through the pipe in order to clean the
pipe, then you can replace the cap. It will make formal ice cubes
Problem
Possible Cause
Suggested Solutions
The compressor works
abnormally with a
Buzzing
noise
The voltage is lower
than recommended
Stop the Ice maker and do not restart
until the voltage is normal.
The light of ADD WATER
is on
There is no water or
water is not enough
Press the “STOP” button, fill with
water, and press the “START” button
again to restart.
