DTC INST 158 – 18.4.11 ISSUE 2
Calibration
Calibration
Calibration
Calibration
Once installed the temperature settings can be adjusted, but note this product is a
sequential mixer and therefore if the maximum outlet temperature is increased the
minimum temperature will also increase.
Turn the shower to fully hot and then turn off the water supply to the valve.
Remove the lever arm (2) and grub screw (1) from head section (3)
Remove grub screw (1) from inside the head section (2) , using the allen key provided.
You must then slightly loosen the nut (1) using a 13mm spanner, insert the allen key
inside the nut and turn the grub screw, turn it anti-clockwise to increase the
temperature.
O
nce the desired temperature is reached, carry out this
instruction in reverse to re-assemble
Installation
Installation
Installation
Installation
Position the mounting bracket (1) over the drilled holes and secure to wall using
screws provided (2)
Next place the trim seals (1), trim plates (2), compression nuts (3) and olives (4) over
pipe ends.
Before installing the valve, if there is a variation in pressure between hot and cold, the
supplied regulators can be used in the elbow (3) to reduce the higher pressure, to do
this, insert the regulator (2) into the elbow, followed by the brass retaining ring (1)
