Deutronic D-IPS Manual - EN
- 8 / 19 -
03 / 2015
D-IPS® und DEUTRONIC® sind eingetragene Marken der Deutronic Elektronik GmbH. Technische Änderungen und Irrtümer vorbehalten.
D-IPS® and DEUTRONIC® are registered trademarks of the Deutronic Elektronik GmbH. Technical modificationses and mistakes reserved.
®
3. Selection „Analog Input 0...10V“ for the voltage target value
After selecting the desired source it will take over when
„
ENTER
“-button is pressed.
After a successful takeover of the source the display shows „Ok“.
When the display shows„no“ the source was not taken over and the selection must be
done once again.
Exit from this menu level with any button „
Src
“ (V).
Press the buttons
„
↓
“ and „
↑
“ at the same time to get out of the menu level, without
overtaking the source. Press the buttons
„
↓
“ and „
↑
“ simultaneous once again to get out of
the menu, then it shows the current values for current and voltage.
6. b) Source input for the current by buttons
Press „
ENTER
“
Select with the buttons „↑“ or „↓“ „
Src
“ (A)
(in this menu item the data source for the target value of the
output current will be selected)
Press „
ENTER
“
There are three menu items fo choose from:
Each source can be selected with the buttons
„↓“ or „↑“
1.
Selection „Internal Source“ for the current target value
2. Source selection „Digital Input“ (like RS232, Ethernet etc.)
3. Selection „Analog Input 0...10V“ for the current target value
