3.0
Installation
- GTD Series Installation, Operation, Maintenance and Parts Manual
Baffle Assembly and Placement
22
Figure 3.18
•
Assembling the Baffles
Figure 3.19
•
Inserting the Baffles
To insert the baffles:
Insert baffles with the keyhole end first.
Rotate baffle assembly so that it is in the
vertical position
.
Slide baffle assembly into the last radiant tube section, furthest from burner control box.
NOTE:
Baffle assemblies longer than 3048mm will continue to be fed into next tube section.
To assemble the baffles:
NOTE:
Baffles may be inserted into the tube while being assembled.
Determine the number of baffles needed for your model number. Remove one 840mm baffle section if
heater is installed with an elbow or U-bend accessory.
Install the baffle tabs at a 90° angle to the baffle keyhole (see Figure 3.18).
Insert one baffle tab into keyhole and slide completely to one side until both baffle tabs appear in
the keyhole.
Adjust the tabs to the center of the keyhole and rotate the baffle 90 degrees to lock the baffle
sections together.
Repeat this process with remaining baffle sections to complete assembly.
1
2
3
4
5
1
2
3
Baffle keyhole
Baffle tabs
Completed connection
IMPORTANT:
Baffle assembly must
be flush with the end of the last tube
section and in the vertical position.
2
3
4
1
2
3
