HOW-TO SECTION
The spin-on type filter consists of a
shell, element and gasket unitized into
a single cartridge and a filter adaptor
which includes threaded inserts
to accept the spin-on cartridges.
See Figure 24.
Figure 24
Typical Spin-On Type
Fuel Filter
An optional fuel/water separator may
be installed in place of the standard
primary filter.
Replace Spin-On Type Primary
or Secondary Fuel Filter
Elements
Replace spin-on fuel filter elements as
follows:
1. Shut down the engine and allow
it to cool.
2. With the engine at ambient
temperature and cool to the touch,
place a suitable container under
the filter.
3. If a fuel shutoff valve is installed
on the discharge side of the
secondary fuel filter, turn the
handle on the shutoff valve to the
closed position (perpendicular to
the valve).
NOTICE:
Have replacement filters filled with
fuel and ready to install immediately.
This prevents possible siphoning
and fuel system aeration.
4. Using a suitable band type filter
wrench, remove the primary and
secondary fuel filters. Dispose of
the filters in an environmentally
responsible manner, according
to federal (EPA) and/or state
recommendations.
5. If not previously filled, fill new
replacement filters with clean
88
All information subject to change without notice. (Rev. 01/04)
6SE484
0401
Copyright © 2004 DETROIT DIESEL CORPORATION
