Detex DSI ES9000-48, Assembly, Installation And Operation Instructions

Page: 9 / 27

9 INS9000 220523
DESIGNED SECURITY INC.
1402 Hawthorne Street Bastrop, Texas 78602
800-272-3555
Fax 512 321 9181
www.dsigo.com
Email: dsi@dsigo.com
If site preparation is complete, you are ready to mount the
pedestals. The pedestal cladding is assembled with
fasteners hidden by acrylic covers. These covers are held
with magnetic strips and can be removed with a suction
cup. Due to characteristics of the magnetic strips used to
fasten the acrylics, each cover must be returned to its
original location and orientation. Each acrylic is labeled
and a corresponding label is found at its location. Return
removed acrylics to matching label location and
orientation.
To mount the pedestal to the floor, you will need to
remove the End Cover, Center Sensor Covers and Motor
Cover.
END REMOVAL STEPS
 Remove Card Reader acrylic cover with suction cup.

Turn thumbscrew 1/4 turn CCW to unlatch.
 While gripping sides of end with the palms of your hands, lift straight up
approximately 3/4” then pull away.

Do not lift by Solid Surface top.
 Repeat for both ends.
CENTER SENSOR COVER REMOVAL STEPS

Remove acrylic sensor covers from center panels with suction cup.

Each cover is attached with 2 Philips-head truss bolts. Remove bolts.
 Remove panels and set aside.
MOTOR COVER REMOVAL STEPS

Remove Center Sensor Cover as noted above. Remove 2 Philips-head truss bolts located toward top of cover.
 Remove motor cover by lifting directly up approximately 1/2”.

Place removed covers in safe location. Take care to avoid damaging finish or creating a hazard to pedestrian traffic.
End Cover
Top Cover
Card Reader Acrylic
Motor Cover
Center Sensor Covers
Lower Sensor Cover
INSTALLATION