1961-M045-O1 Rev B
y
VET-330WH Owner’s Manual
5
SETUP AND INSTALLATION, CONT.
Desk Mounting
1.
The location chosen should be a stable, level surface (either a desk or solid table),
free of temperature extremes and water. The display should be where it can be easily
viewed, not subjected to direct sunlight, and where the keypad is within easy reach of
the operator.
2.
Place the display in the bracket and install the included enclosure knobs. Adjust the
angle of the display for the best viewing, and then completely tighten the knobs. Refer to
the image for Step 5 in the Wall Mounting instructions on the previous page.
AC Power Adapter
To apply power to the scale using the
supplied 120 to 230V AC 15V DC 300 mA
wall plug-in UL/CUL listed AC power
adapter (Cardinal P/N 6800-1044), insert
the plug from the power adapter cable
into the power jack on the right side of the
display (as viewed facing the display) and
then plug AC power adapter into the
proper electrical outlet. The scale is now
ready for operation.
Battery Pack
The VET-330WH scale uses a 7.2V DC, 1200 mA built-in rechargeable battery pack
(Cardinal P/N 6800-1067). The VET-330WH can operate for approximately 8 hours of
continuous use with a fully charged battery pack.
Low Battery Indicator
When the battery pack needs to be recharged, a low battery indicator on the
display will turn on. If the battery voltage drops too low for accurate weighing,
the scale will automatically shut off and you will be unable to turn it back on.
Battery Charging
When the low battery indicator is displayed, the operator should plug the AC power adapter
into the scale display and then into the proper electrical wall outlet. To fully recharge the
battery pack, the AC power adapter must be connected for approximately 14 hours. Note
that the VET-330WH can still be operated while the battery pack is charging. Also, note that
charging the battery pack for more than 14 hours
will not
damage it.
NOTE:
If the AC power adapter is disconnected before the 14 hours, the scale will continue
to charge the battery pack when the AC power adapter is plugged back in.
AC Power
Adapter Plug
AC Power Adapter
