8525-0358-0M Rev-B
•
DR400C/DR550C Operation
6
CONFIGURATION
The scale has been pre-configured at the factory and should not require configuration for use
in most applications. In the event that the factory settings do not meet the requirements of
your application, the following describes the steps to configure the scale.
TO BEGIN CONFIGURATION:
1. Press the
ON / OFF
key to turn on the scale.
2. Press and hold the
TARE
key until the display changes to
Set
.
3. Release the
TARE
key. The display will change to
Unit
.
WEIGHING UNITS
To select desired weighing units:
1. With the display showing
Unit
, press the
TARE
key. The display will change to “kg”.
2. Press the
TARE
key
to display status.
3. Press the
HOLD
key to toggle between: ON or OFF
4. Press the
TARE
key. The display will again show the weighing unit (“kg”).
5. Press the
HOLD
key
to
advance display to lb.
6. Press the
TARE
key
to display status.
7. Press the
HOLD
key
to toggle between: ON or OFF
8. Press the
TARE
key. The display will again show the weighing unit (“lb”).
9. Press the
HOLD
key. The display will show lb and 8/8.
10. This setting is not used. Press the
HOLD
key.
11. The display will again show
Unit
.
12. Proceed to
AUTOMATIC SHUTOFF.
AUTOMATIC SHUTOFF
1. With the display showing
Unit
, press the
HOLD
key.
2. The display will change to show
AOFF
.
3. Press the
TARE
key to begin selection of the automatic shut-off time (in seconds). The
display will change to show the current setting.
4. Press the
HOLD
key to toggle through the selections,
120
,
180
,
240
,
300
, or
OFF
.
5. When the desired time is displayed, press the
TARE
key.
6. The display will change to show
AOFF
.
7. Proceed to
BUZZER (BEEPER)
.
