v.200615
13
ENGLISH
ENGLISH
ASSEMBLY
ASSEMBLY
6.
Install outer bearing (fig.6-3, 11) with the taper facing inward toward the hub.
7.
Install the washer and castle nut (fig.6-3, 14 & 15). Tighten castle nut while turning the tire/hub.
Tighten castle nut until there is resistance while turning the tire/hub.
8.
Install 4 mm cotter pin (fig.6-4, L) through castle nut (fig.6-4, H) and hole in axle end. If holes are
not aligned, slightly loosen castle nut -no more than one castellation-
to align holes.
9.
Spread cotter pin (L) to retain castle nut. See figure 6-4.
10. Pump approximately 8-10 pumps of a hand grease gun into hub.
11.
Install hub dustcap (fig.6-5, 21) firmly on hub with rubber mallet.
12.
Repeat steps 2-11 for the other tire/hub.
13.
While the trailer is still upside down on the ground, move to installing the wiring.
�ig.6-4
�ig.6-5
